HP XP7 Command View Advanced Edition 8.0.0-01 Release Notes

For the AddExternalArrayGroup command in the Device Manager CLI, the KAIC90083-E
(error code = 5601) is generated when all of the following conditions are met:
• P9500 is specified as the internal storage system.
• The pathgroupid parameter is omitted, or a path group ID that does not exist is specified.
• You attempt to virtualize multiple external volumes (more than about 500) at one time by using
the batch functionality.
In this case, virtualize volumes by using an existing external path group, or reduce the number of
volumes to be virtualized at one time.
Analyzing Continuous Access Journal performance with the Replication tab
The Replication tab is not available.
Externally connected volume GUI indication
If you externally connect a volume that is already connected to externally to other storage systems, the
information for the volume will not appear in the Device Manager GUI.
The following example shows that the information about volume 2 does not appear in the Device
Manager GUI, thus becomes inoperable. The information for volumes 1 and 3 will appear.
• The volume 1 from storage system 1 is assigned to the storage system 2 as volume 2.
• Assign volume 2 to storage system 3 as volume 3.
To confirm the information for the volume 2 and operate it, use the Device Manager CLI instead.
Shredding in the Device Manager GUI
It takes at least five minutes to shred each volume.
Copy pair operation times out waiting for specified status
If a copy pair operation is performed from the CLI, the operation might time out and the following
error codes might be displayed:
• KAIC90083-E (error code: 7783)
• KAIC90083-E (error code: 7756) An error occurred during the processing
of the service by the host agent. The host agent error message is Processing
will now stop because the status of the Fast Snap pair was changed and
is now invalid. The command error message is raidcom: [EX_EWSTOT] Timeout
waiting for specified status.
The copy pair operation will continue to run in the storage system even if the operation ends in an
error. To check the status of the copy pair operation, refresh the storage system, then execute one of
the following commands to check the pair status:
• GetStorageArray (subtarget=ReplicationInfo)
• GetStorageArray (subtarget=SnapshotGroup
snapshotgrpsubinfo=ReplicationInfo)*
* This command can only be used for Fast Snap copy pairs.
14 Important considerations