HP XP P9000 Tiered Storage Manager Software 7.6.1-00 CLI Reference Guide

4 Filter conditions that can be used in the
CLI
This chapter provides an overview of the filter condition expressions that can be specified for the
filtercondition parameter and the newfiltercondition parameter, and describes the syntax
and properties that can be specified for filter condition expressions.
Types of filter conditions
For CLI commands that have access to the filtercondition parameter or the
newfiltercondition parameter, filter condition expressions can be specified to limit the command
execution scope, or to use the filtered results to manage storage tiers.
Filter condition expressions are specified by combining properties. Properties in this chapter refer to
comparison-predicate values in the filter condition expressions described in “Syntax of filter
condition expressions” on page 36.
The following table describes the types of filter condition expressions.
Table 4 Types of filter condition expressions
Specifiable properties
Description and commands that
have access to the filter
Filter name and function
The properties to specify
differ depending on the
target (volume or pool)
managed by the storage
tier.
• If the filter targets are
volumes, see Table 5
and Table 8.
Note that some proper-
ties might not be spe-
cifiable for filter condi-
tions that are used to
filter volumes managed
in storage tiers.
• If the filter targets are
pools, see Table 6 and
Table 9.
Filter condition expressions for
volumes and pools in storage tiers
Because a storage tier cannot
manage both volumes and pools at
the same time, volume filter conditions
and pool filter conditions cannot be
specified at the same time.
Commands that have access to this
filter type:
• CreateStorageTier
• ModifyStorageTier
Filter condition expressions for storage
tiers
(storage-tier-filter-condition)
CLI Reference Guide 35