HP XP P9000 Replication Manager Software 7.6.0-00 Configuration Guide

• The memory heap size of Common Component is set to medium.
• The memory heap size of the Device Manager server is set to medium
• Only P9000 Command View AE Command Suite (Device Manager, Tiered Storage Manager,
Replication Manager, and Host Data Collector) is installed on the management server.
• 1000 MB of virtual memory is already allocated for the operating system and other programs.
The calculation is as follows:
1780 (Common Component)
+ 3500 ( P9000 Command View AE Command Suite)
+ 1000 (Allocated virtual memory)
= 6280
Disk space for Replication Monitor log files (5.x upgrade only)
To determine the space required for backing up the Replication Monitor log file, use the following
formula (which uses the settings in the logger.properties file)
logger.MaxBackupIndex * logger.MaxFileSize
For details about the logger.properties file, see “logger.properties” on page 95.
NOTE:
The configuration must always be refreshed when Replication Monitor is upgraded from v5.x to v7.x
Resource Limits
The maximum number of resources that can be managed by Replication Manager depends on the
memory heap size (Small, Medium, or Large). Set an appropriate memory heap size, depending on
the maximum number for each resource.
NOTE:
If you are using a Windows 32-bit environment, you cannot set “Large” as a memory heap size.
For details about how to increase the memory heap size, see the HP P9000 Command View Advanced
Edition Suite Software Installation and Configuration Guide.
This section discusses the following:
• Maximum number of copy pairs, page 39
• Maximum number of LDEVs, page 39
• Log data and number of copy pairs, page 40
NOTE:
Mainframe system resources managed by P9000 RAID Manager must be managed as open system
resources. See “Prerequisites for managing copy pairs on mainframe systems using P9000 RAID
Manager” on page 27 for more information.
Replication Manager system configurations and requirements38