HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 Administrator Guide

DetailsProperty names
Specify the server identification names of RADIUS servers. You can specify any
name for this property in order to identify which RADIUS servers the settings
such as the port number and the protocol for connecting to the RADIUS server
(see Table 39) are applied to. ServerName has been set as the initial value.
You must specify at least one name. When specifying multiple RADIUS server
identification names, separate the names with commas (,). Do not register the
same server identification name more than once.
Specifiable values: No more than 64 bytes of the following characters:
A to Z
a to z
0 to 9
! # ( ) + - . = @ [ ] ^ _ { } ~
Default value: none
auth.server.name
Specify whether to also link to an external authorization server.
Specify true to link to an external authorization server.
Specify false to not to link to an external authorization server.
Default value: false
auth.group.mapping
Table 39 Setup items in the exauth.properties file for RADIUS authentication (settings for the external
authentication server)
DetailsAttributes
Specify the protocol for RADIUS server authentication. This attribute
is required.
Specifiable values: PAP or CHAP
Default value: none
protocol
Specify the host name or IP address of the RADIUS server. If you
specify the host name, make sure beforehand that the host name can
be resolved to an IP address. If you specify the IP address, you can
use either an IPv4 or IPv6 address. When specifying an IPv6 address,
enclose it in square brackets ([]). This attribute is required.
Default value: none
host
#1
Specify the port number for RADIUS server authentication. Make sure
beforehand that the port you specify is set as the listen port number
on the RADIUS server.
Specifiable values: 1 to 65535
Default value: 1812
port
Specify the amount of time to wait before timing out when connecting
to the RADIUS server.
Specifiable values: 1 to 65535 (seconds)
Default value: 1
timeout
Specify the number of retries to attempt when an attempt to connect
to the RADIUS server fails. If you specify 0, no retries are attempted.
Specifiable values: 0 to 50
Default value: 3
retry.times
User account management136