HP XP P9000 Command View Advanced Edition Suite Software 7.5.0-00 Administrator Guide (Web Version) (TB581-96346, July 2013)

DescriptionItem
Displays the serial number of the storage system by using a decimal (base 10)
number.
Serial#
Displays the number of the SLPR to which the command device belongs by using
a decimal (base 10) number.
If no number is defined for the SLPR, a hyphen (-) is displayed.
SLPR#
Displays the CU:LDEV number of the command device by using a decimal (base
10) number.
LDEV#
Displays the command device identifier (the physical drive number, VolumeGUID,
or device file name) recognized by the host.
Device file name
If an unrecognizable value is defined in the perf_cmddev.properties file, that value is dis-
played as UNKNOWN. On lines where the definition does not follow the proper format, all inform-
ation is displayed as UNKNOWN. Comment lines and blank lines are not displayed. In addition, if
no value is specified in the perf_cmddev.properties file, only the header is displayed.
The following is an example of output from the command.
Raid ID Serial# SLPR# LDEV# Device file name
R500 14050 0 345 \\.\PhysicalDrive3
R601 44332 1 456 \\.\Volume{xxxxxxx-xxxx-xxx-xxxxxxxx}
R501 UNKNOWN - 1045 \\.\PhysicalDrive10
verify
This parameter compares the settings for the command devices defined in the file perf_cmd-
dev.properties to the settings for the command devices recognized by the host. If the host
recognizes multiple command devices, the execution result is output for each, regardless of
whether the checked settings are valid.
If the information of a command device defined in the perf_cmddev.properties file
matches the information of the command device recognized by the host, the following message
is displayed:
The definition of the command device is valid.
If the host does not recognize a command device defined in the perf_cmddev.properties
file:
The error message KAIC28615-W and information of the command device that is not recog-
nized by the host are displayed.
If a command device recognized by the host is not defined in the settings file:
The error message KAIC28616-W and information of the command device that is not defined
in the settings file are displayed.
Note that, if the settings for a command device are defined in the perf_cmddev.properties
file by using the format of version 6.3 or earlier, the command device is assumed to belong
to SLPR0.
write
This parameter outputs the settings of all command devices recognized by the host to the
perf_cmddev.properties file. If no command device recognized by the host is detected,
nothing is output to the perf_cmddev.properties file.
Administrator Guide (Web Version) 169