HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Creating a cluster environment 99
StorageWorks Command View XP Advanced Edition software Device Manager server installation and
configuration guide.
The explanation in this section assumes the following conditions:
• In Windows, Device Manager has been installed in C:\Program Files\CVXPAE\ both on the executing
and standby nodes.
• The Command View XP AE Suite product services are online on the executing node.
• A shared disk that can be accessed from both the executing and standby nodes and is registered in the
cluster resources. Additionally, the Command View XP AE product database is stored in the shared disk.
7-2-1 New installation
This subsection describes the procedures for a new installation of the XP Replication Monitor server.
7-2-1-1 In Windows
7-2-1-1-1Installing on the executing node
To install XP Replication Monitor software on the executing node when the OS is Windows:
1. Select Start, Settings, Control Panel, Administrative Tools, and then Cluster Administrator to open the
Cluster Administrator window, and then place the following services offline:
• DeviceManagerServer
• HBase Storage Mgmt Web Service
• HBase Storage Mgmt Common Service
NOTE: Do not place the following resources offline:
- Shared disk
- Cluster management IP address
- Virtual host name
If placed offline, the shared disk cannot be specified during installation.
If the cluster management IP address or virtual host name is placed offline, installation will fail.
2. Execute the following command to stop the Common Component services:
"C:\Program Files\CVXPAE\Base\bin\hcmdssrv" /stop
3. In the Cluster Administrator window, place the following service offline:
HiRDB/ClusterService_HD0
4. In the Cluster Administrator window, right-click the services that were placed offline in steps 1 and 3, select
Property, click the Advanced tab, select Do not restart, and then click OK.
5. Install the XP Replication Monitor server.
For details, see section 2-3-1 .
6. Open the Services window by selecting Start, Settings, Control Panel, Administrative Tools, and Services,
and then make sure that Startup Type for each of the following services is set to Manual. If Startup Type is
set to Automatic, change it to Manual.
• HBase Storage Mgmt Common Service
• HBase Storage Mgmt Web Service
• DeviceManagerServer
• HiRDB/ClusterService_HD0
7. In the Cluster Administrator window, right-click the group to which the Device Manager service
(DeviceManagerServer) has been registered, and then select Move Group to switch to the standby node.
7-2-1-1-2Installing on the standby node
To install XP Replication Monitor software on the standby node when the OS is Windows:
1. Execute the following command to make sure that the Common Component services have stopped: