HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Maintaining and tuning the system 96
6-9-6 Parameters in the base.properties file
The base.properties file is a property file that stores the values for internal processing of the XP Replication
Monitor server are to be set.
Table 6-8 List of parameters in the base.properties.file
Parameter Setting
base.repositry.synchronize.polling The setting that specifies whether XP Replication Monitor software
performs synchronization with the Device Manager database
The parameter can be set to true or false. The value
true specifies that XP Replication Monitor software performs
synchronization. The value false specifies that XP
Replication Monitor software does not perform
synchronization.
6-9-7 Parameters in the server.properties file
The server.properties file is a property file that stores the values of the parameters used by CVXPAE Agent.
NOTE: You must pay particular attention when you change the parameters in the server.properties file
because this file is shared by the Device Manager agent and this change might affect Device Manager agent.
The following table lists and describes the parameter settings in the server.properties file:
Table 6-9
List of parameters in the server.properties file
Parameter Setting
server.agent.shutDownTime * Length of time until CVXPAE Agent's web server function stops after
sending or receiving the last HTTP/XML message (milliseconds)
A value of 0 or less means the shutdown time is undefined.
server.http.socket.bindAddress If CVXPAE Agent is run on a platform where more than 1 network
interface (NIC) is installed, this parameter specifies the NIC from
which CVXPAE Agent can accept requests (IP address: dotted
decimal format).
A blank means that CVXPAE Agent can accept requests from
any NIC.
server.http.socket.agentAddress * IP address that is reported from CVXPAE Agent to Device Manager
Server (IP address: dotted decimal format)
server.http.port TCP port number used by CVXPAE Agent's web server function
The permitted value range is from 1024 to 49151.
server.agent.port TCP port number used by CVXPAE Agent's daemon (service)
The permitted value range is from 1024 to 49151. If this value
is changed, the value of agentif.agentPort in
agentif.properties must also be changed.
server.http.security.clientIP IP address for connecting to CVXPAE Agent (IP address: dotted
decimal format)
A wildcard (*) can be specified. To specify multiple values,
separate each value with a comma (,).
server.agent.rmxp.location RAID Manager XP installation directory
For Windows, use a forward slash (/) as a delimiter for
directories, not a backslash (\).
* Normally, the values set for these parameters do not need to be changed. To change their values, you need
expert knowledge of agents.
6-9-8 Parameters in the agent.properties file
The agent.properties file is a property file that stores the values of the parameters used by the XP
Replication Monitor agent.
The following table shows the setting details for the parameters of the agent.properties file:
Table 6-10 Parameters of the agent.properties file
Parameter Setting details