HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Maintaining and tuning the system 94
Table 6-3 List of XP Replication Monitor software-related parameters
Property file Location of property file Parameter Default value (unit)
server.http.security.clien
tIP
*.*.*.*
server.agent.rmxp.location For a Windows system:
Device-Manager-
agent-
installation-
drive
/HORCM
For a UNIX system:
/HORCM
agent.properties Pair management server agent.rm.TimeOut* 600 (seconds)
agent.rm.everytimeShutdown
*
false
agent.rm.shutdownWait 5 (seconds)
agent.rm.horcmInstance 4094
agent.rm.horcmService 54323
agent.rm.horcmSource Windows system: Value
obtained by converting \
in %WINDIR% to /.
UNIX system: /etc
agent.logger.loglevel INFO
agent.logger.MaxBackupInde
x
5
agent.logger.MaxFileSize 1 MB
* Normally, the values set for these parameters do not need to be changed. To change their values, you need
expert knowledge of agents.
6-9-2 Parameters in the logger.properties file
The logger.properties file is used to set the values of log output parameters.
The following table lists and describes the parameter settings in the logger.properties file:
Table 6-4 List of parameters of in the logger properties file
Parameter Setting
logger.loglevel The threshold value for the XP Replication Monitor server's log file output level
Messages with values that are equal to or less than this threshold value are output
to the log file. The permitted values, in decreasing order of importance, are 0, 10,
20, and 30.
logger.sysloglevel The threshold value for the XP Replication Monitor server's event log or syslog output
level
Messages with values that are equal to or less than this threshold value are output
to the log file. The permitted values, in decreasing order of importance, are 0, 10,
20, and 30.
logger.MaxBackupIndex The XP Replication Monitor server's log file generations
Maximum number of log files that can be created. When the number of log files
reaches this value, the existing files are reused, starting at the first file. The
permitted value range is from 1 to 16.
logger.MaxFileSize The size of the XP Replication Monitor server's log file
Maximum size of a single log file. The permitted value range is from 4096 to
2147483647 in bytes, from 4 to 2097151 in kilobytes, or from 1 to 2047 in
megabytes. If the specified value is not followed by KB or MB, it is treated as
bytes.
6-9-3 Parameters in the serverstorageif.properties file
The serverstorageif.properties file is used to set the value of parameters related to the interface
between the XP Replication Monitor server and Device Manager server.
The following table lists and describes the parameter settings in the serverstorageif.properties file: