HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Maintaining and tuning the system 79
The following describes the storage destinations for the pdutsys file and def_pdutsys file.
installation-folder-for-Common-Component\HDB\conf\pdutsys
installation-folder-for-Common-Component\database\work\def_pdutsys
6. Edit the HiRDB.ini file.
Change the value for the PDHOST parameter to the host name after the change or to the loopback address
127.0.0.1. If the value is changed to 127.0.0.1, this step is unnecessary even if the host name changes
again.
NOTE: Specify a virtual host name for a cluster configuration.
The following describes the storage destination for the HiRDB.ini file.
installation-folder-for-Common-Component\HDB\conf\emb\HiRDB.ini
7. Edit the cluster.conf file (only for a cluster configuration).
Among the virtual host name, host name for the executing node, and host name for the standby node,
change the corresponding host name to the host name after the change.
The following describes the storage destination for the cluster.conf file.
installation-folder-for-Common-Component\conf\cluster.conf
8. Change the host name for the management server, and then restart the machine.
If the host name for the management server has already been changed, simply restart the machine.
9. Make sure that the Common Component service is running.
installation-folder-for-Common-Component\bin\hcmdssrv /status
10. Execute the hcmdschgurl command to change the host name in the URL for starting the web client.
Supplementary explanation:
The hcmdschgurl command is used for updating the access information (URL) in the Common
Component database for starting an application.
For details on how to use the hcmdschgurl command, see the manual HP StorageWorks Command View
XP Advanced Edition software Device Manager server installation and configuration guide.
6-3 Starting or terminating services
This section explains how to start and stop the services of the XP Replication Monitor server and the XP
Replication Monitor agent, and how to stop an instance of RAID Manager XP used by XP Replication Monitor
software.
To execute the open system commands explained in this section, you must log in as an administrator group user.
6-3-1 Starting or terminating XP Replication Monitor services
This subsection explains how to start and stop the XP Replication Monitor server services.
XP Replication Monitor software operates as part of HBase Storage Mgmt Web Service, a service of Common
Component. Therefore, the XP Replication Monitor server services are started and stopped by starting and
stopping Common Component services.
6-3-1-1 Starting Services of XP Replication Monitor server
To start the XP Replication Monitor server services, execute the following command:
Common-Component-installation-folder\bin\hcmdssrv /start