HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Changing the configuration of XP Replication Monitor software 68
• Start time for deleting data whose retention period has elapsed (time at which data deletion is to start each
day)
The procedures for specifying and changing the LUN Security XP Extension settings are the same as for initial
setup. For details, see section 3-6 .
4-1-6 Acquiring the most recent configuration information
The procedure for acquiring the most recent configuration information is the same as for initial setup.. For details,
see section
3-7 .
NOTE: You do not need to acquire the recent configuration information again, because the information is
already acquired if you selected the check box in the dialog box so that configuration information of copy
pairs managed by information sources (Device Manager or Business Continuity Manager) is collected when
you registered the information source.
4-1-7 Backing up the XP Replication Monitor database
You must back up the XP Replication Monitor database when its contents change due to adding information
sources and updating the configuration.
To back up the XP Replication Monitor database, execute Common Component hcmdsbackups command. For
details about executing the hcmdsbackups command, see section
3-8 .
4-2 Deleting an information source
4-2-1 Flow of information source deletion tasks
Figure 4-2 shows the task flow for information source deletion processing.