HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Changing the configuration of XP Replication Monitor software 66
4 Changing the configuration of XP Replication Monitor
software
This chapter describes the procedures for adding and deleting information sources. You must add and delete
information sources when the system configuration changes. The chapter also explains the task flows for these
procedures.
• Adding an information source (section
4-1 )
• Deleting an information source (section
4-2 )
4-1 Adding an information source
4-1-1 Flow of information source addition tasks
Figure 4-1 shows the task flow for information source addition processing.
Figure 4-1 Task flow for information source addition
4-1-2 Preparations before adding an information source
Before adding an information source to the system, you must use the Common Component hcmdsbackups
command to back up the database. For details about backing up a database, see section 3-8 .