HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Establishing XP Replication Monitor software initial settings 58
Table 3-2 Setting units for the information collection interval and the copy pairs that are targeted
Information Source Setting Unit Original Source of
Information
Targeted Copy Pairs
Pair management
server
Agent
2
Agent
2
Copy pairs managed by the
pair management server
Device Manager server
Information source
1
Device Manager server
3
All copy pairs in the storage
subsystems managed by the
Device Manager server
Business Continuity
Manager
Information source Business Continuity
Manager
Copy pairs managed by the
information source
1
The same settings are used for all copy pairs of the information source.
2
The existing settings for each pair management server are overwritten by each information source. If you need the settings of
a particular pair management server, specify the pair management server settings after you specify the settings for each
information source.
3
You can configure the system so that Device Manager is not refreshed when you perform a manual refresh (see section 3-5-
2 ).
Figure 3-13 shows sample collection interval settings for collecting information related to copy pair status when
the information source is a Device Manager server. In this figure the pair management servers A and B are
managed by the management server 1, and the pair management server C is managed by the management
server 2.
Figure 3-13 Collection interval settings for collecting information related to copy pair status
Assuming that the collection interval for information related to copy pair status is set as shown in this figure, and
assuming that the information collection interval is set in order of (1) each information source, and (2) each pair
management server, the information collection intervals for the copy pairs managed by each pair management
server are 15, 10, and 5 minutes each for pair management servers A, B, and C, respectively.