HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Installing XP Replication Monitor software 31
Supplementary explanation:
The window for prompting you to set the information required for XP Replication Monitor software to
access Device Manager appears only when the HiRDB setup status is noncluster configuration or cluster
configuration (executing node). If the status is cluster configuration (standby node), step 8 is skipped,
and a window confirming installation information appears.
8. Enter the Device Manager user account (user ID and password), and click the Next button. If you need to
change the displayed port number (default value: 2001) to another value, enter the user account and the
new port number, and then click the Next button. The password must be entered twice (the second entry is
compared with the first entry to confirm that they are identical).
The Pre-installation confirmation window indicates that preparation for the installation is complete. This
window displays installation information such as the installation destination.
NOTE: When the user account and port number required for XP Replication Monitor software to access
Device Manager are not entered, or if the port number is outside the acceptable range, an error message
prompts you to re-enter the information.
Supplementary explanation:
The user account and port number set in this procedure are required for using Device Manager
functions from XP Replication Monitor software. XP Replication Monitor software uses the account to
access Device Manager. The specified user account must have Modify permission in Device Manager
and All Resources allocated to its resource group. Device Manager uses the port number for HTTP
communications.
Supplementary explanation:
The user ID and password must each consist of 1 to 256 characters. If you specify 257 characters or
more, the operation might fail. The following characters can be specified:
Item Specifiable characters
User ID A-Z a-z 0-9 # + - . @ _
Password A-Z a-z 0-9 ! # $ % & ' ( ) * + - . = @ \ ^ _ |
At this point, the user account specified in this procedure is not checked as to whether it is valid and
effective as a Device Manager user account. This will be checked when installation has completed
normally and XP Replication Monitor software performs an automatic or manual refresh.
Supplementary explanation:
Enter the same password twice. If the first and second input values are not identical, an error message
prompts you to re-enter the information.
Supplementary explanation:
Execute the port number change only when you need to change the port number to values that are
different from the displayed default value, such as when another application with the same port number
exists on the platform that executes the XP Replication Monitor server.
The number 2001 is the default value for the port number used by Device Manager in HTTP
communications. If Device Manager has specified a port number other than the default, specify that
port number.
The port number can be specified using a number from 1 to 65535.
9. Check the displayed installation information, and then click the Execution button.
Installation begins and windows appear indicating the status of the process.
When the installation has completed normally, the Installation Complete window appears.
In the following cases, the Installation Stopped or Installation Has Stopped window appears:
• When you instruct the installer to stop the installation by clicking the Cancel button.
• When the installation stops because an error occurred during the installation.
10. Click the Finish button to finish the installation.
The window closes.