HP StorageWorks XP Replication Monitor software installation and configuration guide (T1784-96008, November 2006)

Creating a cluster environment 106
C:\Program Files\CVXPAE\Base\bin\hcmdsdbremake /cluster /databasepath
R:\re_creating_db
NOTE: For database-recreation-folder, use an absolute path of no more than 63 bytes to specify the
same folder that was specified when a database was re-created on the shared disk in the executing
node.
Note that a file separator cannot be used at the end of a name for database-recreation-folder. If it is
used, a command error occurs. In this case, remove the file separator, and re-execute the command.
NOTE: For details about how to set the port used by HiRDB, see the manual HP StorageWorks
Command View XP Advanced Edition software Device Manager server installation and configuration
guide.
Supplementary explanation:
Even when other Command View XP AE Suite products are in operation, you need to execute this step
only.
Supplementary explanation:
Common Component is restarted on the standby node during this step.
4. Execute the following command to stop Common Component services (HBase Storage Mgmt Web Service
and HBase Storage Mgmt Common Service) and databases:
Common-Component-installation-folder\bin\hcmdssrv /stop
5. Select Start, Setting, Control Panel, Administrative Tools, and Services. Open the following service
properties in the Service window, and then change Startup Type from Automatic to Manual.
• HBase Storage Mgmt Web Service
• HBase Storage Mgmt Common Service
• DeviceManagerServer
Supplementary explanation:
When Command View XP AE Suite products other than XP Replication Monitor software and Device
Manager are operating on the same management server with the XP Replication Monitor server, see the
manual for each product to determine whether Startup Type of the Command View XP AE Suite product
needs to be changed.
6. Register the resources shown below (such as shared resources and services) into the cluster software.
However, if the resources have been registered on the executing node, you do not need to register the
resources on the standby node.
For details on how to register the resources into cluster software, see the manual HP StorageWorks
Command View XP Advanced Edition software Device Manager server installation and configuration guide.
• IP address of cluster manager
• Virtual host name
• The shared disk where the database is created
• The following services:
- HBase Storage Mgmt Web Service
- HBase Storage Mgmt Common Service
- DeviceManagerServer
- HiRDBClusterService_HD0
Supplementary explanation:
When Command View XP AE Suite products other than XP Replication Monitor software and Device
Manager are operating on the same management server with the XP Replication Monitor server, see the