HP StorageWorks XP Command View Advanced Edition Common Component Security Guide Description and Operator's Guide (T1780-96308, July 2009)

Preparations before System Creation

3 Preparations before System Creation

This chapter describes the preparations required for creating a system in the configuration

evaluated based on ISO/IEC 15408 for HP StorageWorks XP Command View Advanced Edition

Common Component.

• Selecting the Storage Management Software (See section 3-1 )

• Installing Hardware (See section 3-2 )

• Setting Up the Operating System (See section 3-3 )

• Determining the Rules Related to Security Functions (See section 3-4 )

3-1 Selecting the Storage Management Software

Select the HP StorageWorks XP Command View Advanced Edition software required for system

operation according to subsection 1-3-3 and section 2-2 , and then obtain the components, such as

media and license key, required for installation.

3-2 Installing Hardware

Install the hardware in the system according to subsection 1-3-2 and section 2-1 . Also set up a

firewall as described in the firewall documentation. The required settings vary depending on the HP

StorageWorks XP Command View Advanced Edition software that is used. For the actual settings,

see the applicable reference in the following table.

Table 3-1 Firewall Settings

Management software being used See:

XP Command View Device Manager HP StorageWorks XP Command View Advanced Edition

software server installation and configuration guide for

Device Manager and Provisioning Manager

2 Device Manager network configuration

2-3 Working with a network that uses a firewall

5 XP Command View AE Suite Common Component

5-4 Ports used by XP Command View AE Suite Common

Component

XP Command View Provisioning Manager --

When setting up the firewall ports, permit communication only for the ports that are indicated in the

above manuals and that either will be used in the system being created or are required by the

prerequisite software or for system operation. Set up the firewall to block communication through

any other ports. Also specify the setting that, when a port number is changed, communication

passes for the new port number and blocked for the old port number.

3-3 Setting Up the Operating System

Install the prerequisite operating system on the management server machine according to

subsection 1-3-3 and section 2-2 , and specify the required settings.