HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

DescriptionAttribute
Type of the parity group
For P9500, XP24000/XP20000, or XP12000/XP10000/SVS200, one of the
following values is output:
• -1: None
• 0: Normal parity group
• 1: External volume parity group
• 2: Snapshot V-VOL parity group
• 3: Thin Provisioning Software volume parity group
-1 is output for other storage systems.
type
Option information of the external parity group
For P9500, XP24000/XP20000, or XP12000/XP10000/SVS200, a 3-bit value
is converted to decimal and is output.
• Bit 0 (0x01): Whether or not the cache mode is enabled
• Bit 1 (0x02): Whether or not the I/O suppression mode is enabled
• Bit 2 (0x04): Whether or not the cache inflow control mode is enabled
For each of these bits, 1 means enabled and 0 means disabled. For example,
when the cache mode and the cache inflow control mode are enabled, 5 is output
as the value of the volumeType attribute.
-1 is output in other cases.
volumeType
Indicates whether the data that is stored in the parity group is encrypted.
For P9500 or XP24000/XP20000, one of the following values is output:
• 0: The data is not encrypted.
• 1: The data is encrypted.
-1 is output for other storage systems.
encrypted
Protection level of the parity group
For P9500 or XP24000/XP20000, one of the following values is output:
• 0: Standard
The parity group consists of drives other than SATA drives
• 1: SATA-W/V
The parity group consists of SATA drives
• 2: SATA-E
The parity group consists of SATA drives and the write performance is more
enhanced than SATA-W/V
-1 is output if any of the following conditions are satisfied:
• The protection level of the parity group is unknown.
• The parity group is of the internal volume to which an external volume is
mapped.
• The parity group is a Thin Provisioning Software volume parity group.
• The parity group is a Snapshot V-VOL parity group.
• The XP24000/XP20000 microcode version is 60-04-10-XX/XX or earlier
-1 is output for other storage systems.
protectionLevel
Currently, this information does not apply to storage systems (-1 is output).thpPoolID
CLI Reference Guide 287