HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

hdvmcli [URL] GetReplicationControllerPair
Parameters
Table 103 GetReplicationControllerPair command parameters
DescriptionStatusParameter name
Serial number of the storage system that contains the main control
unit (MCU)
Optional
#
masterserial-
num
CU number of the MCU
Optional
#
mastercontrol-
lerid
Serial number of the storage system that contains the remote
control unit (RCU)
Optional
#
remoteserial-
num
SSID of the RCU
Optional
#
remotessid
Model of the storage system that contains the MCU
Optional
#
mastermodel
Family of the storage system that contains the RCU
Optional
#
remotefamily
Path group ID of the RCU
Optional
#
remotepathgrou-
pid
#
The following describes the parameter combinations that can be specified:
• You need to specify the masterserialnum, mastercontrollerid, remoteserialnum,
and remotessid parameters at the same time. If you do not specify them at the same time, an
error will occur.
• If you specify the mastermodel, remotefamily, or remotepathgroupid parameter, you
also need to specify all other parameters (masterserialnum, mastercontrollerid, re-
moteserialnum, remotessid, mastermodel, remotefamily, and remotepathgroupid).
If you do not specify them at the same time, an error will occur.
• If you omit all the parameters, the command will obtain the information about all replication con-
troller pairs.
Parameter values to obtain in advance
Execute the GetReplicationControllerPair command without specifying any parameters, and
then obtain the values from the execution result. Specify the value of masterSerialNumber that is
displayed as An instance of ReplicationControllerPair in the masterserialnum
parameter, the value of masterControllerID in the mastercontrollerid parameter, the value
of remoteSerialNumber in the remoteserialnum parameter, the value of remoteSSID in the
remotessid parameter, the value of masterArrayType in the mastermodel parameter, the
value of remoteArrayFamily in the remotefamily parameter, and the value of
remotePathGroupID in the remotepathgroupid parameter.
CLI Reference Guide 277