HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionAttribute
Number of virtual volumes assigned to the pool
For example, for XP24000/XP20000, when poolFunction is 5, the number of
volumes for Thin Provisioning Software assigned to the pool for Thin Provisioning
Software is output.
numberOfVVols
Total capacity of the virtual volumes assigned to the pool (KB)
For example, for XP24000/XP20000, when poolFunction is 5, the total
capacity of the volumes for Thin Provisioning Software assigned to the pool for
Thin Provisioning Software is output.
capacityOfVVolsInKB
CLPR number of the pool
The CLPR number is output for the pool that corresponds to the function type output
to poolFunction.
clprNumber
Currently, this information does not apply to storage systems.
raidLevel
Currently, this information does not apply to storage systems.
combination
Currently, this information does not apply to storage systems (-1 is output).volAlertNotice
Over-provisioning percent (%)
If the storage system is P9500 or XP24000/XP20000 and poolFunction is 5,
the ratio of the total size of all volumes for Thin Provisioning Software compared
to the pool size for Thin Provisioning Software is output.
This value is output as a whole number.
This information is invalid for other cases (-1 is output).
overProvisioningPer-
cent
Over provisioning warning threshold (%)
If the storage system is P9500 or XP24000/XP20000 and poolFunction is 5,
the threshold used to issue an advance warning for the over-provisioning percent
is output.
This information is invalid for other cases (-1 is output).
overProvisioning-
Warning
Over provisioning limit threshold (%)
If the storage system is P9500 or XP24000/XP20000 and poolFunction is 5,
the threshold used to report an excess limit for the over-provisioning percent is
output.
This information is invalid for other cases (-1 is output).
overProvisioningLim-
it
Drive revolutions per minute
If the storage system is P9500 and a pool for Thin Provisioning Software is used,
the rotational speed (RPM) is output. For an unknown drive or a drive of a different
rotational speed, -1 is output.
This information is invalid for other cases (-1 is output).
rpm
CLI Reference Guide 313