HP P9000 Tiered Storage Manager Software 7.4.0-00 CLI Reference Guide (TB585-96027, December 2012)

Specifiable values or charactersOperatorsProperty name
For GetStorageArray
(subtarget=LogicalUnit) in Device
Manager CLI, specify the value
displayed for the raidType attribute
of the LogicalUnit object.
Specify this in the format of RAIDx, or
RAIDx(yD+zP).
RAIDx: RAID level
yD: Number of data drives
zP: Number of parity drives
Specify no more than 75 bytes.
=, <>RAIDLevel
For GetStorageArray in Device
Manager CLI, specify the value
displayed for the name attribute of the
StorageArray object.
Specify no more than 384 bytes.
=, <>SubsystemName
For GetStorageArray in Device
Manager CLI, specify the value
displayed for the vendor attribute of
the VolumeConnection object.
Specify no more than 150 bytes.
=, <>SubsystemVendor
Specify a positive integer, or a positive
integer with a unit. (For example, 256,
500KB, or 10MB.)
Specify an integer from 0 to
9,223,372,036,854,775,807KB
The units you can specify are KB,
MB, GB, and TB. KB is the default
unit.
#1
=, <>, >, >=, <, <=TotalFreeCapacity
#1
When possible, capacity values in the output information of CLI commands are expressed in a
higher-order unit than the unit specified by the user. For example, the value 10,240 KB is displayed
as 10MB.
#2
For the drive capacity, a value in KB is obtained from Device Manager. However, in Tiered
Storage Manager software, the gigabyte-conversion of those values is used. This conversion in-
volves dividing the drive capacity by 1,048,576 (1,024 x 1,024) and then rounding to the
nearest integer.
Table 11 Restrictions on specifiable characters for property values of filter condition expressions
Characters that cannot be specifiedProperty name
A value must be specified.
If multiple values are specified and separated using commas
(,), any spaces at the beginning or end of the ArrayGroup
names are ignored.
ArrayGroup
CLI Reference Guide 49