HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

DescriptionStatusParameter name
Option information that determines whether logical units are to
be created at the same time an external parity group is created
Either of the following values can be specified:
• none: No logical unit is created.
• create: Logical units are created.
If this parameter is omitted, none is set.
Optional
luoption
Number of logical units to be created
The only valid value is 1.
If this parameter is omitted, 1 is set.
This parameter cannot be specified if none is specified in the
luoption parameter or if the luoption parameter is omitted.
Optional
numoflus
Device number of the logical unit
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
If this parameter is omitted, a value is automatically set by Device
Manager.
This parameter cannot be specified if none is specified in the
luoption parameter or if the luoption parameter is omitted.
Optional
devnum
Volume size of the logical unit
If this parameter is omitted, a logical unit having the same size
as the external volume is created.
This parameter cannot be specified if none is specified in the
luoption parameter or if the luoption parameter is omitted.
Optional
capacity
Unit for the value to be specified in the capacity parameter
Either of the following values can be specified:
• KB
• block
If this parameter is omitted, KB is set.
This parameter cannot be specified if none is specified in the
luoption parameter or if the luoption parameter is omitted.
Optional
capacitytype
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. For the
storage system where you want to create an external parity group, specify either an arrayType
value or a displayArrayType value for the model parameter. Use the serialNumber value
to specify the serialnum parameter.
portname
Obtain this value from the execution result of the GetStorageArray (subtarget=Port)
command executed on the storage system where you want to create an external parity group.
Then, for the portname parameter, specify the displayName value of the port whose portRole
value is External. At this time, record the worldWidePortName value.
CLI Reference Guide 47