HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

GetReplicationControllerPair
GetReplicationControllerPair obtains information about a replication controller pair.
In P9500, XP24000/XP20000, XP12000/XP10000/SVS200, and XP1024/XP128, replication
controller pairs indicate paths between MCUs and RCUs.
Format
When obtaining information about a replication controller pair:
hdvmcli [URL] GetReplicationControllerPair [options]
masterserialnum=serial-number-of-the-storage-system-containing-the-MCU
mastercontrollerid=CU-number-of-the-MCU
remoteserialnum=serial-number-of-the-storage-system-containing-the-RCU
remotessid=SSID-of-the-RCU
[mastermodel=model-of-the-storage-system-containing-the-MCU
remotefamily=family-of-the-storage-system-containing-the-RCU
remotepathgroupid=path-group-ID-of-the-RCU]
When obtaining information about all replication controller pairs:
hdvmcli [URL] GetReplicationControllerPair [options]
Parameters
Table 111 GetReplicationControllerPair command parameters
DescriptionStatusParameter name
Serial number of the storage system that contains the main control
unit (MCU)
Optional
#
masterserial-
num
CU number of the MCU
Optional
#
mastercontrol-
lerid
Serial number of the storage system that contains the remote
control unit (RCU)
Optional
#
remoteserial-
num
SSID of the RCU
Optional
#
remotessid
Model of the storage system that contains the MCU
Optional
#
mastermodel
Family of the storage system that contains the RCU
Optional
#
remotefamily
Path group ID of the RCU
Optional
#
remotepathgrou-
pid
#
The following describes the parameter combinations that can be specified:
• You need to specify the masterserialnum, mastercontrollerid, remoteserialnum,
and remotessid parameters at the same time. If you do not specify them at the same time,
an error will occur.
CLI Reference Guide 315