HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

Parameters
Table 105 GetURLLink command parameters
DescriptionStatusParameter name
The object ID of the URLLink for which you want to obtain
information
Specify the object ID obtained from another CLI response. The
value is encoded by the CLI.
Do not specify this parameter with the linkedid parameter. If
they are specified at the same time, an error will occur.
Optional
#
objectid
The object ID of the Device Manager object
Information about all the URLLinks set for the specified Device
Manager object is acquired. Specify the object ID obtained from
another CLI response. The value is encoded by the CLI.
Do not specify this parameter with the objectid parameter. If
they are specified at the same time, an error will occur.
Optional
#
linkedid
Type of the Device Manager object for which the URLLink is set
One of the following values can be specified. The values are not
case-sensitive.
• smi-s: SMI-S Enabled storage system
• other: Device Manager object other than an SMI-S Enabled
storage system
Optional
#
targetoption
#
• If objectid, linkedid, and targetoption are all omitted, all URLLink information will
be acquired for all of the Device Manager objects, regardless of the type.
• If both objectid and linkedid are omitted but targetoption is specified, all URLLink
information for all of the Device Manager objects of the type specified for targetoption
will be acquired.
• If either objectid or linkedid is specified and targetoption is omitted, other is set
for targetoption.
Parameter values to obtain in advance
None.
Command execution example
hdvmcli GetURLLink -o "D:\logs\GetURLLink.log"
"objectid=*****"
"targetoption=smi-s"
*****: The value is encoded by the CLI.
CLI Reference Guide 289