HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

NOTE:
This command does not support virtualization servers.
Parameters
Table 98 ModifyHostInfo command parameters
DescriptionStatusParameter name
Object ID of the HostInfo record to modify
Specify the object ID obtained from another CLI response. The
value is encoded by the CLI.
Required
objectid
New serial number of the path's storage system
Omit this when no change is required.
Optional
serialnum
New model of the path's storage system
Omit this when no change is required.
Optional
model
New name of the HostInfo
Omit this when no change is required.
You can use a character string of 1-50 bytes for the name.
Optional
hostname
New IPv4 IP address of the host
Omit this parameter if you are not changing the IPv4 IP address
of the host.
Optional
ipaddress
New IPv6 IP address of the host
Omit this parameter if you are not changing the IPv6 IP address
of the host.
Optional
ipv6address
New mount point on the host file system corresponding to the
path
Omit this when no change is required.
Optional
mountpoint
New port on the path
Omit this when no change is required.
When this is changed, port or portname must be specified.
Do not specify both parameters at the same time. If they are
specified at the same time, an error will occur.
Optional
port
New port name of the path
Omit this when no change is required.
When this is changed, port or portname must be specified.
Do not specify both parameters at the same time. If they are
specified at the same time, an error will occur.
Optional
portname
Command reference276