HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

An instance of Host
objectID=*****
name=toro2
hostID=279
ipAddress=192.168.32.63
capacityInKB=0
hostType=-1
statusOfDBUpdating=0
*****: The value is encoded by the CLI.
AddHostInfo
AddHostInfo adds host-based information about a LUN (information about storage used by hosts).
NOTE:
This command does not support virtualization servers.
Parameters
Table 87 AddHostInfo command parameters
DescriptionStatusParameter name
Serial number of the path's storage systemRequired
serialnum
Model of the path's storage systemRequired
model
Name of the HostInfo
You can use a character string of 1-50 bytes for the name.
Required
hostname
IPv4 IP address of the hostOptional
ipaddress
IPv6 IP address of the hostOptional
ipv6address
Mount point on the host file system corresponding to the pathOptional
mountpoint
Port that the path is on
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
port
Port name that the path is on
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
portname
Domain ID of the path
This parameter can be specified in decimal and hexadecimal. If
you specify a hexadecimal number, add the 0x prefix.
The execution results are output in decimal.
Required
domain
Command reference248