HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

NOTE:
• For XP24000/XP20000 and XP12000/XP10000/SVS200, the partitioned storage administrator
cannot obtain all the information about paired volumes and external volumes.
• For XP24000/XP20000, if there is information about copy pairs consisting of mainframe volumes,
microcode version 60-01-6X-XX/XX or later is required.
Parameters
Table 56 GetStorageArray (subtarget=MFReplicationInfo) command parameters
DescriptionStatusParameter name
Specify MFReplicationInfo.
Required
subtarget
Serial number of the storage system.
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
model
ID of the mainframe volume copy pair information
(MFReplicationInfo instance)
Specify this parameter to obtain information about a copy pair
of a specific mainframe volume.
If you specify this parameter, you must also specify the model
and serialnum parameters. If you specify the model and
serialnum parameters and do not specify the objectid
parameter, information is obtained about copy pairs made up of
mainframe volumes on the specified storage system.
Optional
objectid
LDEV information related to mainframe-volume copy pairs.
LDEV is the only value that you can specify.
Optional
mfreplication-
subinfo
Starting sequence number of the copy pair information of
mainframe volumes for which information is to be obtained
Specify this parameter to obtain information about copy pairs of
some mainframe volumes from a specific storage system.
When mainframe-volume copy pair information is in the order
shown below and starts from 0, specify the first number in the
sequence of the mainframe-volume copy pair information that you
want to obtain.
Order of mainframe-volume copy pair information:
1. Serial numbers of P-VOLs in ascending order
2. Device numbers of P-VOLs in ascending order
3. Serial numbers of S-VOLs in ascending order
4. Device numbers of S-VOLs in ascending order
This parameter must be specified together with the
numOfElementsFilter, model, and serialnum parameters.
Optional
startElement-
NumFilter
Command reference156