HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

Parameters
Table 51 GetStorageArray (subtarget=FreeSpace) command parameters
DescriptionStatusParameter name
Specify FreeSpace.
Required
subtarget
Serial number of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
model
Object ID of a parity group that has unused capacity
Specify this parameter when you want to obtain information about
the unused capacity of a specific parity group. If you specify this
parameter, you must also specify the model and serialnum
parameters. If you specify the model and serialnum
parameters, and omit the arraygroupobjid parameter,
information about the unused capacity of all the parity groups in
the specified storage system is obtained. Specify the object ID
obtained from another CLI response. The value is encoded by the
CLI.
Optional
array-
groupobjid
Parity group name
The following value specification formats can be used:
• n
• n - n
• n - n - n
• E n - n
• V n -1
• X n -1
Here, n is an integer of 1 or greater, while E, V, and X are fixed.
If this parameter is specified, the model parameter must also be
specified.
Optional
arraygroupname
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
arraygroupobjid
Obtain this value from the execution result of the GetStorageArray (subtarget=ArrayGroup)
command. Execute this command by specifying only the model and serialnum parameters,
and ArrayGroup for subtarget=ArrayGroup. In the execution result of this command, the
objectID value appears under An instance of ArrayGroup. Use this objectID value
to specify the arraygroupobjid parameter.
Command reference138