HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

hdvmcli [URL] DeleteVirtualVolume [options]
model=model serialnum=serial-number [deletionoption=force]
devnums=device-number-of-THP-volume
#
If the microcode version is 60-04-XX-XX/XX or later and the system option 726 is set to ON,
you cannot specify this format. If you specify this format, an error will occur.
Parameters
Table 39 DeleteVirtualVolume command parameters
DescriptionStatusParameter name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Specifies whether to delete THP volumes that have not been
released from the THP pool.
To delete such THP volumes, specify force.
Optional
(XP24000/XP20000)
deletionoption
Name(s) of the virtual parity group(s).
Use a comma to delimit multiple values.
Optional
arraygroup-
names
#
Device number(s) of the THP/Smart volume(s).
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Optional
devnums
#
#
Always specify either the arraygroupnames parameter or the devnums parameter. Do not
specify both parameters at the same time. If they are specified at the same time, an error will
occur.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
arraygroupnames
Obtain this value from the execution result of the GetStorageArray (subtarget=ArrayGroup)
command. In the execution result of this command, displayName appears under An instance
of ArrayGroup. Use this value to specify the arraygroupnames parameter.
devnums
Obtain this value from the execution result of the GetStorageArray (subtarget=LDEV)
command. Execute this command by specifying only the model and serialnum parameters,
and LDEV for the subtarget parameter. In the execution result of this command, the devNum
Command reference108