HP P9000 Command View Advanced Edition Suite Software 7.2 Administrator Guide (web)

server.mail.alert.type
This property specifies the type of alerts that are sent to users by email. The following values can be
specified:
• Trap: Reports only the alerts detected by SNMP traps.
• Server: Reports only the alerts detected by the regular monitoring that Device Manager conducts.
• All: Reports the alerts detected by both SNMP traps and the regular monitoring that Device
Manager conducts. Alerts are reported from both SNMP traps and Device Manager even if these
alerts refer to the same error information.
Default: Trap
server.mail.alert.status
This property specifies the severity of alerts that are sent to users by email. The Device Manager server
reports alerts whose severity is equal to or higher than the severity specified for this property. The
following values (listed in ascending order of severity) can be specified:
Normal, Service, Moderate, Serious, Acute
Default: Moderate
server.subsystem.ssid.availableValues
This property specifies the range of the SSIDs that can be assigned automatically to storage systems
registered in Device Manager.
This property is valid for XP1024/XP128, XP12000/XP10000/SVS200, XP24000/XP20000 and
P9500.
The values that can be specified for this property are as follows:
• Hexadecimal numbers in the range from 4 to FFFD: To specify consecutive numbers, use a hyphen
(-) to specify the range. To specify non-consecutive numbers, use commas as separators. The
values are not case sensitive. If multiple values and ranges that include duplicated numbers are
specified, the logical union of all specified values is used.
• All: The string All specifies that the entire range of values can be specified. This value is not
case sensitive.
Automatic SSID assignment can be performed only when a value or values are specified in this
property.
Default: All
server.smisclient.indication.port
This property specifies the port number used to receive event indications from SMI-S providers.
Specifiable range: 1024 to 49151.
Default: 5983
If the setting value of this property has been changed, you must refresh any SMI-S Enabled storage
system that is managed by Device Manager.
Device Manager server properties320