HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)
Installing Command View SDM 51
Installing
Command View SDM
wildcards is recommended when connecting from clients configured for
dynamic host configuration protocol (DHCP).
3 Save the configuration file.
Removing a Client
Use the above procedure to remove a host you no longer want to have access.
When removing clients it is necessary to stop and restart the HostAgent to
implement the change. See "Starting/Stopping HostAgent and OpenDIAL" on
page 55.
Configuring the Command View SDM Web Server
The Command View SDM software includes its own web server, which is
installed along with the other software components. By default, the web server
is enabled on port 4096. If you need to change its port, you can do so using
the following procedure.
Changing the Web Server Port
By default, the Command View SDM web server listens for http requests on
port 4096. If this port is not available on your system, you can specify a
different port. The port is specified in the following parameter in the
configuration file ..\
sanmgr\commandview\server\browser\conf.xml:
<Set name="Port">4096</Set>
Change the value to an available port number.
Restarting the HostAgent Service
After making changes to the configuration PanConfigParams.txt file, you
must stop and restart the HostAgent service on the server. For information on
performing this operation, refer to "Starting/Stopping HostAgent and
OpenDIAL" on page 55.
Note HP OpenView SAM Implementation
On HP OpenView SAM you must stop and restart the HP
OpenView Storage Management Server service, not HostAgent.
This is done from the Services dialog accessed from the Control
Panel.