HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)
Installing Command View SDM 49
Installing
Command View SDM
them to a temporary directory and restore after installation. Firmware file can
be identified by the .frm extension and are typically located in the
...\sanmgr\commandview\client\fwdownload for arrays
...\sanmgr\commandview\client\sbin for JBOD.
Should I Save the Host Port Behavior and Secure Manager Tables?
The host port behavior table and the Secure Manger table are maintained in
the array and should not be impacted by the installation of a new version of
Command View SDM. However, for added security you may want to consider
saving copies of the LUN security table file and the host port behavior table
file. If necessary, these files can be used to replicate or restore security and
port behavior on the array.
Restoring Array Configuration Information
After Command View SDM has been installed on the host, the saved
configuration can be restored as follows:
1 Replace files access.dat and ContactInfo.txt with the saved
versions of the files.
2 Update the PanConfigParams.txt file using one of the following
steps:
a If you have upgraded to a new version of Command View SDM, the
newer version will include configuration settings that will be erased if
you replace the new PanConfigParams.txt file with the older
saved file. Instead, open both files in a text editor, identify any
configuration settings you have changed in the saved file, update the
new file with the changes., and save the updated file.
b If you are replicating the configuration on another host running the
same version of Command View SDM, simply replace the existing
PanConfigParams.txt with the saved version.
3 Restart HostAgent and OpenDIAL to invoke the new configuration. See
"Starting/Stopping HostAgent and OpenDIAL" on page 55.