HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

48 Installing Command View SDM
Saving and Restoring Array Configuration
Information
Several configuration files are used to customize the operation of
Command View SDM. Because these files allow you to easily replicate or
restore the configuration of your array, it is recommended that you maintain
copies of these files. This is particularly important if you plan to upgrade to a
newer version of Command View SDM. After the new software has been
installed, these files can be copied into the newly installed files to recreate the
desired operating configuration. Before restoring the older files, you may want
to compare them with newly installed files (some of the old files may be the
same).
Note To prevent the configuration files from being deleted when you
uninstall the existing Command View SDM software to upgrade
to a newer version, make sure the copies are in a location
outside the Command View SDM installation path.
There are three configuration files that should be saved:
HP-UX and Linux
/opt/sanmgr/commandview/server/config/PanConfigParams.txt
/opt/sanmgr/commandview/server/config/ContactInfo.txt
/opt/sanmgr/hostagent/config/access.dat
/opt/sanmgr/hostagent/config/commIpAddr.txt
Windows
\Program Files\Hewlett-Packard\sanmgr\commandview\server\config\PanConfig-
Params.txt
\Program Files\Hewlett-Packard\sanmgr\commandview\server\config\ContactInfo.txt
\Program Files\Hewlett-Packard\sanmgr\hostagent\config\access.dat
Windows - HP OpenView Storage Area Manager
\Program Files\Hewlett-Packard\sanmgr\commandview\server\config\PanConfig-
Params.txt
\Program Files\Hewlett-Packard\sanmgr\commandview\server\config\ContactInfo.txt
\Program Files\Hewlett-Packard\sanmgr\managementserver\config\authorizedClients.dat
In addition, if you have downloaded any firmware update files stored within
the Command View SDM installation path, and would like to save them, copy