HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

46 Installing Command View SDM
What’s Next?
■ If the software was installed on a host connected to an array, refer to
"Configuring Command View SDM" on page 50 for additional
configuration information.
■ If the software was installed on a client, see "Setting up Remote Client
Access" on page 50 for information on assigning client access rights.
Note Two Command View SDM daemons are installed on the client
that are only required on the host connected to the array. They
may be shut down on a client. To shut down these daemons,
refer to "Starting/Stopping HostAgent and OpenDIAL" on
page 55.
Uninstalling Command View SDM from Linux
This procedure describes uninstalling the Command View SDM software. The
existing Command View SDM software should be uninstalled before installing
a new version of the software. The uninstall process does not automatically
delete the array log files. If you want to delete the log files, you will have to do
so manually.
Note The 1.07 and 1.08 versions of linux installer will not correctly
remove earlier versions of the Command View Software.
Previously installed versions on linux should be uninstalled using
the uninstaller for that version of Command View. If the 1.07
uninstaller is used, the following steps may be taken to ensure
all the unnecessary files are removed after uninstallation
process completes:
rm -fR /opt/sanmgr/hostagent
rm -fR /var/opt/sanmgr/hostagent
rm -fR /etc/opt/sanmgr/hostagent
1 If you are upgrading to a newer version of Command View SDM, save any
configuration files you may have customized. See "Saving and Restoring
Array Configuration Information" on page 48.
2 Uninstall the Command View SDM software:
uninstall_cmdview