HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Installing Command View SDM 41
Installing
Command View SDM
1 Right click on the Command View SDM Launcher icon on the client desk
top.
2 Select Properties > Short Cut.
3 In the Target: window, append a space and the host identification to the
end of the path displayed. The host can be identified by either its DNS
name or IP address. In the following figure, the IP address 10.62.126.238
is added to the target path.
4 Click OK.
Note - To manage an array from a remote client, the client must be
granted access by the Command View SDM host the Launcher is
connecting to. See "Setting up Remote Client Access" on
page 50 for more information.
- You can create additional Launcher icons connecting to
different Command View SDM hosts by right clicking on the
Launcher icon and selecting Create Shortcut. This will create a
duplicate of the existing icon, which you can then modify to
connect to a different host.
Add the IP address
or the DNS name of
the CommandView
host