HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

36 Installing Command View SDM
Installing Command View SDM on Windows
The following procedure describes the steps involved in installing the
Command View SDM software on a Windows 2000/2003 host or client.
Minimum System Requirements for Windows
Before installing the Command View SDM software, verify that the host meets
the following minimum requirements.
Selecting a Host IP Address on Systems with Multiple IP
Addresses
During installations where multiple IP addresses exist on a host (i.e. multiple
LAN cards in a single host), only one of the IP address will be entered into the
<INSTALLDIR>\hostagent\config\commlpAddr.txt file. If this is not the correct
address, the hostagent will not communicate with the array.
After installation, check the contents of the
<INSTALLDIR>\hostagent\config\commlpAddr.txt file. If the correct IP address
is not shown, manually enter the correct IP address.
Host
■
Administrator privileges (Required)
■ Windows 2000 SP4 (32Bit), Windows 2000 AS SP4 (32Bit)
and Windows 2003 server Enterprise Edition (32Bit)
■ 500 MHz processor speed or better
■ 1 GB RAM
■ Screen resolution 800 x 600 (for GUI use)
(Recommended resolution: 1024 X 768)
■ Video support: 64K colors or better
■ Disk space for logs: 16 Mbyte per 2 months
■ Disk space:
60 Mbytes of permanent space for the application
30 Mbytes of temporary space in the Windows Temp directory
(typically C:/Temp) used during installation