HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

142 Command Line User Interface
-d Set the fibre channel to its default settings.
-D <alias> Set the array alias name (limited to 256 bytes).
-f {on | off} Set Auto Format Drive on or off. Default is on.
When enabled, any disk that does not have 520-byte sectors will be
automatically reformatted when installed in the array. If the disk already
has 520-byte sectors, no formatting operation will take place.
-h {None|Automatic|
LargestDisk |
LargestTwoDisks}
Specify Hot Spare operation. Default is Automatic.
None - no hot spare.
Automatic - the array will determine the appropriate amount of hot spare
space. For 15 or fewer disks in a redundancy group, the array will
reserve enough capacity to rebuild the largest disk. For 16 or more disks,
the array will reserve enough capacity to rebuild the two largest disks.
LargestDisk - reserve enough space to complete a rebuild after a failure
or removal of the largest drive in the redundancy group.
LargestTwoDisks - reserve enough space to complete a rebuild after a
failure or removal of the largest two drives in the redundancy group
Firmware HP01 and HP02:
-h {on|off}
On - turn on hot spare
Off - turn off hot spare
-hd {on|off} Enable Hang Detection. Default is on. Hang detection should only be
disabled if continued controller resets are occuring as the result of false
triggers.
-i {on | off} Set Auto Include on or off. Default is on. On allows the array to
automatically include any disk when it is installed into the array: Off
requires the disk to be manually included after it is installed.
-I <FRULocation> {on | off} Identify an FRU location by flashing the FRU LED:
on - flash an LED on the FRU, if possible
off - stop flashing the LED.