HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Command Line User Interface 135

Command Line User Interface

created file to the array using the armhost command. If a behavior for a

host is not include in the table, the default controller behavior will be used.

Creating the Host Port Behavior Table

The host port behavior table is created as a text file which is downloaded to

the array. The entries in the file are used to create the array’s host port

behavior table. The file contains two values per line: one value identifying the

WWN of the host, and one value specifying the host operating system. Blank

lines or lines starting with the character “#” are ignored.

File entries use the following format:

<node_WWN> <host_port_behavior>

<node_WWN> is the node WWN or port WWN of the host

<host_port_behavior> identifies the host operating system. The values for

each OS are listed in the following table>

node_WWN> identifies the WWN connection to the host. A host connection

may be the host WWN or it may be the host adapter WWN. Either the node

or port WWN may be used. For hosts that have multiple host adapters, more

than one entry (WWN) per host may be required in the host port behavior

Host Operating System <host_port_behavior> Value

HP-UX HPUX

Windows 2000/2003 Win2k

Linux Red Hat Linux

Sun Solaris Solaris

Novel Netware NetWare

IBM AIX AIX

MPE/iX MPE

Compaq Tru64

Tru64

Compaq OpenVMS

OpenVMS

Other operating systems

UnsupportedOS

Supported on firmware versions HP14 and later