HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

114 Command Line User Interface
-D -P <productID> Download firmware to the disk identified by the -P <productID> option.
See the -P option for more information.
-I Display a list of controllers (C), Disks (D), LCCs (L), or Battery controller (B)
locations and firmware revision codes for the module type specified.
-L
<FRULocation> Download firmware to the disk enclosure LCC controller identified by
<FRULocation>. Multiple controllers can be specified in the same
command.
-L -P
<productID> Download firmware to the disk enclosure LCC controller identified by the -
P
<productID> option. See the -P option for more information.
-M <source_FRU> Copy firmware from the array controller identified by <source_FRU> to
the other array controller.
-O Perform the download in an offline mode. This is required for family
firmware version changes. An attempt to download a version family
change with the array on-line, an error will be returned indicating that an
off-line (-O) download is required.
Note - during the download the array will not respond to I/O.
-P <productID> Download firmware to all LCCs (C) or all disks (D) identified by
<productID>, the product number of the module.
<fwFileName> Identifies the file containing the firmware to be downloaded. The path
must be included.
Command View SDM creates the following default directories for
firmware files, but firmware files may be placed in any directory.
opt/sanmgr/commandview/client/fwdownload << HP-UX or Linux
<drive>:\Program Files\Hewlett-
Packard\sanmgr\commandview\client\sbin\fwdownload <<Windows
<FRULocation> Identifies the specific FRU that the download operation is to be performed
on.
? Display extended usage message. This option overrides all other
switches.