Manualshelf

HP EVA-to-3PAR Online Import Migration Guide

ManualsBrandsHP ManualsSoftwareHP Command View EVA Software
21222324252627282930
The Confirm Migration Destination screen is displayed.
NOTE: If any object selected for migration is not ready for data migration, the appropriate
status is displayed in the Migration OK? column, and the Next button is disabled. In this case,
click Export Selections to save the selections information to a file for troubleshooting. Then
click Cancel to stop the migration wizard. Using the saved selections information, fix this issue
and run the migration wizard again.
8. Ensure that the 3PAR Destination Storage System is ready for migration. Click Next.
The Configure Destination Volumes screen is displayed.
NOTE: If the Migration OK? status is not OK, the tooltip provides information on why the
migration cannot be performed until the necessary action is taken.
9. Set the Configuration to Set individually.
10. Set the Destination Virtual Volume Attributes.
a. Select the desired Destination Provisioning (Thin or Full) for the Destination Virtual Volume.
b. Select the desired Destination CPG (Common Provisioning Group) for the Destination
Virtual Volume.
c. To use these settings for all the virtual volumes, set the Configuration to Set all the
same. To use different settings for each volume, repeat the steps for each volume.
11. Click Next.
The Summary screen is displayed.
12. Review the summary information and click Add Migration.
The Host HP EVA to 3PAR StoreServ Online Import Status Summary page is displayed with
the newly added migration in the list of Migrations in Progress. The Preparation status displays
a clock indicating that migration preparation is being performed. When complete, the
Preparation status changes to Done. The Completed button is displayed in Data Transfer
indicating that the host must be unzoned from the EVA before beginning the migration.
13. Perform the following steps on the host:
a. Stop all applications on the EVA vdisks that must be migrated.
b. Note the Volume Group to Physical Volume Identifier mapping using the lspv command.
Migrating an IBM AIX host 21