HP QLogic Converged Network Adapter Installation Guide (747713-001, September 2013)

Figure 1 QLogic Converged Network Adapter
4. If a different mounting bracket is required, change the bracket as follows. Otherwise, proceed
to Step 5.
a. Remove any transceivers or cables from the CNA transceiver cage assembly by pulling
the bail (handle) out and down to release the latch, and then gently pull the transceiver
out. Do not force it. After you release the latch, the transceiver/cable slides out easily.
Figure 2 A typical optical transceiver
Figure 3 Removing a transceiver
HP Restricted Installing the CNA 7