HP ProLiant Networking Software Release Notes

3) To verify that the driver installed correctly and that the host port is seen by the switch, verify that the
host WWPN shows up in the switch FLOGI database:
For Cisco FCF: show flogi database
For Brocade FCF: fcoe --loginshow
VMware installation and configuration known issues
---------------------------------------------------
Boot from SAN on ESXi 5.0.x
Boot from SAN is not supported on ESXi 5.0.x.
Multipath configuration
To set up multipath on an ESXi 5.x host, you must add a default FCoE transport SATP rule. For
instructions, search for the article 2045934 on the VMware Knowledge Base website
(http://kb.vmware.com).