HP P6000 Cluster Extension Software Installation Guide (5697-2275, November 2012)

2. Make sure that the cluster management application is not running on the cluster nodes where
you plan to install P6000 Cluster Extension.
NOTE: Failover Cluster Management is used on Windows Server 2008/2008 R2/2012.
For Windows Server 2012 and Windows Server 2012 Server Core, ensure that powershell
cmdlets module for failover clustering is enabled.
3. Run the installer by doing one of the following:
• Double-click the P6000 Cluster Extension installation package.
• Run the P6000 Cluster Extension installation package from the command prompt. This
option is used for Server Core or Hyper-V Server installation. For more information about
installing applications in a Server Core or Hyper-V Server environment, see your Microsoft
documentation.
The installer prompts you to check the HP SPOCK website (http://www.hp.com/storage/
spock) to verify that supported versions of the array firmware and other required software are
installed.
4. Verify that the correct software is installed, and then click OK.
5. Follow the instructions to accept the license agreement, view the Readme file, and enter your
identification.
The Setup Type dialog box appears.
6. In the Setup Type dialog box, select one of the following options, and then click Next:
• Select Typical to install the resource DLL, cluster administrator extension DLL, and
documentation.
• Select Compact to install only the resource DLL and cluster administrator extension DLL.
• Select Custom to select specific components to install.
The Cluster node selection dialog box appears.
7. Select the cluster nodes for P6000 Cluster Extension installation, and then click Next.
The Choose Destination Location dialog box appears.
Installing P6000 Cluster Extension Software 13