HP P6000 Cluster Extension Software Installation Guide (5697-0987, June 2011)

You can use the CLI for custom cluster software integration. For example, you can write your own
online and offline scripts using advanced DR group status checking options.
NOTE:
Installing the CLI is not required if you are using P6000 Cluster Extension Software with MSCS.
To install P6000 Cluster Extension:
1. Make sure that the cluster service is running.
2. Make sure that the cluster management application is not running on the cluster nodes where
you plan to install P6000 Cluster Extension.
NOTE:
Failover Cluster Management is used on Windows Server 2008/2008 R2, and Cluster
Administrator is used on Windows Server 2003.
3. Run the installer by doing one of the following:
• Double-click the P6000 Cluster Extension installation package.
• Run the P6000 Cluster Extension installation package from the command prompt. This option
is used for Server Core or Hyper-V Server installation. For more information about installing
applications in a Server Core or Hyper-V Server environment, see your Microsoft documenta-
tion.
The installer prompts you to check the HP SPOCK website (http://www.hp.com/storage/spock)
to verify that supported versions of the array firmware and other required software are installed.
4. Verify that the correct software is installed, and then click OK.
5. Follow the instructions to accept the license agreement, view the Readme file, and enter your
identification.
The Setup Type dialog box appears.
Installing P6000 Cluster Extension Software for Windows16