HP P6000 Cluster Extension Software Administrator Guide (5697-0986, June 2011)

Valid values Disabled (default)
Enabled
FailsafeMode Override (Optional)
Format String
Description Specifies whether P6000 Cluster Extension can disable the failsafe mode configured
for the DR group during a failover, if necessary. This property is used only if
FailsafeMode is enabled for the DR group. Disabling FailsafeMode might leave
the data at the destination site in a noncurrent state; setting FailsafeModeOverride
to YES provides the highest level of data availability with the compromise of data
currency at the destination site. This property applies to synchronous DR groups
only.
Valid values NO (default)
YES
MergeCheckInterval
Format Integer
Descrip-
tion
Specifies the check interval (in seconds) for checking the status of the DR group synchron-
ization (merging). It might take a while to synchronize member vdisks. You can set this
value if the ApplicationStartup property is set to RESYNCWAIT.
Default
value
20
PostExecCheck (Optional)
Format String
Description The PostExecCheck object is used to configure P6000 Cluster Extension to gather
P6000/EVA disk pair status information after the takeover procedure. That inform-
ation will be passed to the post-executable. In case of a remote data center failure,
it could be time consuming to gather that information, especially if your post-execut-
able does not need any P6000/ EVA status information. The arguments passed to
the post-executable will include only the local disk status if the PostExecCheck object
is set to NO.
Valid values YES
NO (default)
PostExecScript (Optional)
Format String
HP P6000 Cluster Extension Software Administrator Guide 83