HP P6000 Cluster Extension Software Administrator Guide (5697-0986, June 2011)

Default value 10 seconds

ClusterNotifyWaitTime

Format Integer

Description Specifies the amount of time that P6000 Cluster Extension will monitor for VM live

migration state changes.

Default value 5 seconds

CSObjectPathA (Required)

Format String

Description Specifies the HPEVA_ConsistencySet object path for the DR group in data center

A. This object path is used in sending management commands directed at the

P6000 Continuous Access DR group.

MSCS-specific behavior

This is a private property for the P6000 Cluster Extension resource type within

MSCS. P6000 Cluster Extension automatically runs the Connection Test and updates

the consistency set object paths as necessary when the OK or Apply buttons is se-

lected on the Parameters tab.

RHCS and SLE HA-specific behavior

When configuring P6000 Cluster Extension for RHCS and SLE HA, you must enter

this object into the P6000 Cluster Extension resource configuration file (/etc/opt/

hpclxeva/conf/CLXEVA.config). To obtain the value of this object, run the

clxconf utility (see “clxconf” on page 91).

CLI-specific behavior

You must enter this object in the user configuration file (UCF.cfg) when you use

P6000 Cluster Extension's CLI. To obtain the value of this object, run the clxconf

utility (see “clxconf” on page 91).

CSObjectPathB (Required)

Format String

Description Specifies the HPEVA_ConsistencySet object path for the DR group in data center

B. This object path is used in sending management commands directed at the