HP P6000 Cluster Extension Software Administrator Guide (5697-0986, June 2011)

NOTE:
When you configure P6000 Cluster Extension resource properties using the CLI, the properties you
enter are not validated, so you must enter the property values accurately, and verify them against the
P6000 Cluster Extension documentation.
You can display all attributes of the P6000 Cluster Extension resource clx_fileshare with the
following command:
cluster resource clx_fileshare /privprop
The following example changes the CSObjectPathA property for the resource clx_fileshare:
cluster resource clx_fileshare /privprop CSObjectPathA=
"HPEVA_ConsistencySet.InstanceID=""50001FE15002B5A0.6005-08b4-
0001-2b69-0000-6000-86a0-0000"""
To retrieve the values for CSObjectPathA and CSObjectPathB, you must create and configure a
UCF.cfg file for this DR group and run the clxconf -smis command. The values for both objects
are stored in the clxobjpaths.cfg file.
NOTE:
This step is not necessary when using the Cluster Administrator or Failover Cluster Management GUI.
The following example changes the name of the resource P6000 Cluster Extension resource1
to P6000 Cluster Extension resource2:
cluster resource "P6000 Cluster Extension resource1" /ren:"P6000 Cluster Extension resource2"
Setting P6000 Cluster Extension properties using a UCF
You can use a UCF to configure certain P6000 Cluster Extension properties for Windows.
Properties that you can configure in a UCF include:
• LogLevel
• ClusterNotifyCheckTime
• ClusterNotifyWaitTime
• DataSyncTimeout
• MergeCheckInterval
• StatusRefreshInterval
IMPORTANT:
If you plan to use the default values for these properties, no UCF is required.
To configure properties using a UCF:
1. Take the P6000 Cluster Extension resource offline.
HP P6000 Cluster Extension Software Administrator Guide 45