HP EVA Cluster Extension Software Installation Guide (5697-2446, July 2013)
Table Of Contents
- HP EVA Cluster Extension Software Installation Guide
- Contents
- 1 Preparing to install HP EVA Cluster Extension
- 2 Installing HP EVA Cluster Extension Software
- Prerequisites
- Pre-installation procedures
- Checking the IP network setup and SAN configuration
- Installing multipath software
- Installing and configuring the JRE
- Installing and configuring HP EVA SMI-S on all management servers
- Configuring the HP EVA storage system
- Creating hosts
- Creating vdisks and adding a LUN presentation
- Creating DR groups
- Setting read-only mode and adding a LUN presentation to the destination vdisk
- Installing MSCS on all nodes
- Installing HP EVA Cluster Extension Software
- Upgrading HP EVA Cluster Extension Software
- HP EVA Cluster Extension maintenance
- Troubleshooting installation and maintenance problems
- 3 Licensing
- 4 Support and other resources
- Glossary
- Index
Repairing the HP EVA Cluster Extension installation
Once HP EVA Cluster Extension is installed, you can repair the installation.
1. Start the HP EVA Cluster Extension InstallShield wizard:
a. Depending on your version of Windows, perform one of the following steps:
• For Windows Server 2008/2008 R2/2012: Select Start→Control Panel→Programs
and Features.
• For Server Core or Hyper-V Server: Run the HP EVA Cluster Extension installation
package from the command line. Continue to Step 2.
b. Select HP EVA Cluster Extension. Click Uninstall/Change (Windows Server 2008/2008
R2/2012).
The InstallShield maintenance window appears.
2. Select Repair and then click Next.
The Cluster node selection window appears.
3. Select the cluster nodes to repair and then click Next.
The InstallShield wizard notifies you that remote maintenance is in progress.
4. For each remote maintenance confirmation window, click OK.
The Maintenance Complete window appears.
5. Click Finish to close the InstallShield wizard.
Removing HP EVA Cluster Extension
1. Ensure that the cluster management application is not running.
Failover Cluster Management is used on Windows Server 2008/2008 R2/2012.
2. Start the HP EVA Cluster Extension InstallShield wizard:
a. Depending on your version of Windows, perform one of the following steps:
• For Windows Server 2008/2008 R2/2012: Select Start→Control Panel→Programs
and Features.
• For Server Core or Hyper-V Server: Run the HP EVA Cluster Extension installation
package from the command line. Continue to Step 3.
b. Select HP EVA Cluster Extension. Click Uninstall/Change (Windows Server 2008/2008
R2/2012).
The InstallShield maintenance window appears.
3. Select Remove and then click Next.
The InstallShield wizard prompts you to confirm the uninstallation request.
4. Click Yes to confirm the request.
The Cluster node selection window appears.
5. Select the cluster nodes for HP EVA Cluster Extension removal and then click Next.
The install wizard prompts you to save the clxevacfg file. This file contains information
about the HP EVA Cluster Extension configuration. If you save the file, you can import it later
to restore your HP EVA Cluster Extension configuration.
6. Execute one of the following operations:
• Click Yes if you want to save the clxevacfg file. Enter a file name, and then click Save.
• Click No.
HP EVA Cluster Extension maintenance 19