HP EVA Cluster Extension Software Installation Guide (5697-2446, July 2013)
Table Of Contents
- HP EVA Cluster Extension Software Installation Guide
- Contents
- 1 Preparing to install HP EVA Cluster Extension
- 2 Installing HP EVA Cluster Extension Software
- Prerequisites
- Pre-installation procedures
- Checking the IP network setup and SAN configuration
- Installing multipath software
- Installing and configuring the JRE
- Installing and configuring HP EVA SMI-S on all management servers
- Configuring the HP EVA storage system
- Creating hosts
- Creating vdisks and adding a LUN presentation
- Creating DR groups
- Setting read-only mode and adding a LUN presentation to the destination vdisk
- Installing MSCS on all nodes
- Installing HP EVA Cluster Extension Software
- Upgrading HP EVA Cluster Extension Software
- HP EVA Cluster Extension maintenance
- Troubleshooting installation and maintenance problems
- 3 Licensing
- 4 Support and other resources
- Glossary
- Index
Creating vdisks and adding a LUN presentation
Create the storage (vdisks) for your application data using the SSSU or the P6000 Command View
GUI, and then present the vdisks to the cluster nodes connected to that HP EVAarray.
NOTE: At a later time in this installation process, you can create a LUN presentation for your
remote destination vdisk and set the access mode property for the destination vdisk to read-only.
See “Setting read-only mode and adding a LUN presentation to the destination vdisk” (page 11).
For detailed instructions, see the HP P6000 Command View User Guide or the HP Storage System
Scripting Utility Reference.
10 Installing HP EVA Cluster Extension Software