HP EVA Cluster Extension Software Administrator Guide (5697-2445, July 2013)

NOTE: When using HP P6000 Command View 8.0.2 or later, if you created new DR groups,
the groups might not show up immediately in the Select DR Group dialog box. To make a
new DR group available in the EVA Cluster Extension GUI, do one of the following:
• Wait 30 minutes after creating the DR group.
• Restart the HP CIM Object Manager service after creating the DR group. This service must
be restarted on all Command View servers configured for the Cluster Extension EVA
resource.
• Run CLIRefreshTool.bat for both arrays. This tool, located in the Install
Path\Hewlett-Packard\SMIS\CXWSCimom\bin directory, is installed with HP EVA
SMI-S. This tool must be run on all Command View servers configured for the Cluster
Extension EVA resource. See the EVA SMI-S documentation for more information.
3. Click Apply to finish your modifications and leave the window open, or OK to save your
changes and close the Properties window.
Changing DR group settings
The cluster software resource configuration GUI and the resource configuration tool display the
DR group name, write mode, and failsafe mode. Use the cluster software HP EVA CLX Settings tab
or the resource configuration tool to edit the advanced DR group settings to control failover behavior
for the DR group that you use with the EVA Cluster Extension.
1. Click Advanced Settings.
The Advanced settings dialog box appears.
Configuring Cluster Extension EVA resources 33