HP 3PAR StoreServ Cluster Extension Software Administrator Guide

6. Click OK to save your changes and close the Advanced settings window.
7. Click Apply to save your changes and leave the window open, or click OK to save your
changes and close the Properties window.
Configuring takeover actions
Pre-executables and post-executables can be defined to be executed before or after HP 3PAR
StoreServ Cluster Extension invokes its takeover functions. Use the cluster software Parameters tab
or the resource configuration tool to add or remove pre/post executable scripts.
1. Click Pre/Post Exec to display the Pre/Post Executable Properties dialog box.
2. Update the PreExecScript, PostExecScript, and PostExecCheck values as needed, and then
click OK.
3. Click Apply to finish your modifications and leave the Properties window open, or click OK
to save your changes and close the window.
Setting HP 3PAR StoreServ Cluster Extension resource properties using the MMC
If you are using Server Core or Hyper-V Server, you can manage a cluster remotely by using the
MMC to run Failover Cluster Management.
NOTE: When you configure HP 3PAR StoreServ Cluster Extension resource properties from a
remote management station through the MMC which uses the standard Microsoft Properties tab,
the properties you enter are not validated. You must enter the property values accurately, and
verify them against the HP 3PAR StoreServ Cluster Extension documentation.
When you use this option, you will see the default Microsoft properties page instead of the HP
3PAR StoreServ Cluster Extension Parameters tab. For more information about using the MMC,
see “Remote management of HP 3PAR StoreServ Cluster Extension resources in a cluster” (page 52)
and your Microsoft documentation.
Setting HP 3PAR StoreServ Cluster Extension resource properties using the CLI
The cluster commands in this section can be used with Windows server core and non server core
environments.
The Windows cluster default properties for a resource can be changed using the following command:
cluster resource <resource_name> /privprop [<object_name=value|"value1
value2 ...">]
NOTE: When you configure HP 3PAR StoreServ Cluster Extension resource properties using the
CLI, the properties you enter are not validated, so you must enter the property values accurately,
and verify them against the HP 3PAR StoreServ Cluster Extension documentation.
Setting HP 3PAR StoreServ Cluster Extension-specific resource properties 43