HP 3PAR StoreServ Cluster Extension Software Administrator Guide

Table 2 Service or application properties and values (continued)
ValueDescriptionFormatProperty
If this value is set to a
number higher than the
current number of clustered
systems for the cluster group,
the service or application
will continue to restart until
either the
FailoverThreshold
value or the
FailoverPeriod
timeout value is reached.
Setting HP 3PAR StoreServ Cluster Extension-specific resource properties
Changes to resource properties take effect when the resource is brought online again. For instructions
on changing resource properties, see:
• “Setting HP 3PAR StoreServ Cluster Extension resource properties using the GUI” (page 36)
• “Setting HP 3PAR StoreServ Cluster Extension resource properties using the MMC ” (page 43)
• “Setting HP 3PAR StoreServ Cluster Extension resource properties using the CLI” (page 43)
• “Setting HP 3PAR StoreServ Cluster Extension properties using a UCF” (page 44)
Setting HP 3PAR StoreServ Cluster Extension resource properties using the GUI
This section describes the procedures for setting HP 3PAR StoreServ Cluster Extension resource
properties with a GUI. You can perform these procedures through the resource configuration utility
using the cluster software GUI Failover Cluster Management or the standalone resource configuration
utility in Server Core or Hyper-V Server.
TIP: For information on managing HP 3PAR StoreServ Cluster Extension resources from a remote
management station through the MMC, see“Setting HP 3PAR StoreServ Cluster Extension resource
properties using the MMC ” (page 43) .
Using Failover Cluster Management to set resource properties
To set resource properties, use the Failover Cluster Management GUI:
1. Open Failover Cluster Management.
2. Double-click the HP 3PAR StoreServ Cluster Extension resource in the summary pane to open
the Properties window.
3. Click the HP 3PAR StoreServ CLX Settings tab.
36 Configuring HP 3PAR StoreServ Cluster Extension